Mitsubishi Heavy Industries SRK25GZ-L1 Handbook page 68

SRK-H
2.4.2 Details of operation control
(1) Flap control
Control the flap by the flap button on the wireless remote control
(a) AUTO (Natural flow)
The flap will be automatically set to the angle of air flow best to operation mode
1) Starting time of operation
In case of cooling and
s t
dry operation
Stops at the level
position for one minute.
Sway operation
¡The flap operation as shown above
will repeated.
2) When not operating
The flap returns to the position of air flow directly below, when operation has stopped.
(b) Memory flap
While the flap is operating if the AIRFLOW button is pushed once, it stops swinging at an angle.
As this angle is memorized in the microcomputer, the flap will be automatically set to the angle when next operation is
started.
¡ Recommendable stopping angle of the flap
COOL . DRY
(c) Swing flap
Flap moves in upward and downward directions continuously.
66
In case of heating
s t
operation
Sway operation
Stops at the position
for three minutes
and fifty seconds
¡ When the room temperature controller (thermo-
stat) is activated, horizontal blowing is applied
to prevent cool wind from blowing out.
Horizontal
blowing
Air flow when flaps are used
downward in heating
Warm are naturally rises.
Warm air is sent to the floor, creating the ideal room tem-
perature variation is created in which the feet are warmer and
the air around the head slightly cooler.
HEAT
Slant forward
blowing