Avaya Communication Manager Administrator's Manual page 1657

Disconnect Signal Error (sec)
This field appears for ground-start trunk groups.
Valid entries
1 to 255 in
increments of 1
Flash Length (msec)
This timer is sent to TN436B, TN459B, TN464C (or later), TN465B (or later), (TN753 if Country
is 23), TN2146, TN2147, TN2184, and TN2199 circuit boards.
Valid entries
10 to 2550 in
increments of 10
Glare
This field is only administrable if the Trunk Type field is cont and the trunk group Direction field
is two-way or outgoing. Only TN2140 ports receive this timer.
Valid entries
40 to 100 in
increments of 10
Incoming Dial Guard (msec)
Valid entries
10 to 2550 in
increments of 10
Usage
Enter the maximum interval that Communication Manager will wait to
receive a disconnect signal from the far-end after the local party (a
telephone or tie trunk) goes on-hook. If the timer expires, Communication
Manager assumes a disconnect failure and takes appropriate action, such
as creating an error message.
Usage
Enter the duration of a flash signal generated toward the central office.
Usage
Enter the minimum acceptable interval (in msec) between the moment
your server running Communication Manager sends an outgoing seizure
and the moment it receives a seizure acknowledgment. If
acknowledgment is received before the timer expires, glare is assumed.
Usage
Enter the minimum acceptable interval between the detection of an
incoming seizure and the acceptance of the first digit. Communication
Manager will not accept digits before this timer expires.
This timer is never sent to TN429 ports.
Trunk Group
Issue 2.1 May 2006 1657