Avaya Communication Manager Administrator's Manual page 1610

Screen Reference
Outgoing Display
This field allows display telephones to show the name and number of the trunk group used for
an outgoing call before the call is connected. This information might be useful to you when
you're trying to diagnose trunking problems.
Valid entries
y
n
Prefix-1
Use this field for outgoing and two-way trunk groups handling long distance service. This field
appears for CO, FX, and DIOD trunk groups.
Valid entries
y/n
Protocol Type
This field specifies the type of line signaling protocol used for DID and DIOD trunk groups. This
field appears when the Country field is 15 and is used only by trunk group members
administered on a TN2199 or TN464D vintage 3 or later circuit pack. For a list of country codes,
see the Country code table
Valid entries
inloc (Incoming local)
intol (Incoming toll)
Queue Length
Outgoing calls can wait in a queue, in the order in which they were made, when all trunks in a
trunk group are busy. If you enter 0, callers receive a busy signal when no trunks are available.
If you enter a higher number, a caller hears confirmation tone when no trunk is available for the
outgoing call. The caller can then hang up and wait: when a trunk becomes available,
Communication Manager will call the extension that placed the original call. The caller will hear
3 short, quick rings. The caller doesn't need to do anything but pick up the handset and wait:
Communication Manager remembers the number the caller dialed and automatically completes
the call.
1610 Administrator Guide for Avaya Communication Manager
Usage
Displays the trunk group name and number.
Displays the digits the caller dials.
Usage
Enter y to add the prefix "1" to the beginning of the digit string for outgoing
calls. Do not enter y for trunk groups in AAR or ARS route patterns.
on page 1514.
Usage
Enter the protocol the central office is using for this trunk group.
Only the inloc protocol provides ANI.