Charging System
Alternator Overhaul (cont'd)
Special Tools Required
. Driver 07749-0010000
. Attachment, 52 x 55 mm 07746-0010400
NOTE: Refer to the Exploded View as needed during
t h i s p r o c e d u r e .
1. Test the alternator and regulator before you
remove them (see page 4-22).
2. Remove the alternator (see page 4-26).
3. lf the front bearing needs replacing, remove the
pulley locknut with a 10 mm wrench (A) and a
22 mm wrench (B). lf necessary, use an impact
wrencn.
Remove the three flange nuts (A) and the screw (B)
from the alternator, then remove the plate terminal
1 C ) _
a."8
g
-------.....---a
t '
4-30
5. Remove the washer nut (A) and insulator (B) from
the "B" terminal, then remove the end cover (C)
a n d d u s t s e a l ( D ) .
a-9
6. Remove the brush holder.
@
E
6:Or
€ d l
r[,F