Removing And Installing Brake Servo - Skoda Kodiaq 2017 Workshop Manual

3.3

Removing and installing brake servo

⇒ "3.3.1 Removing and installing brake booster, left-hand drive,
except for Bi-Turbo diesel engine", page 95
⇒ "3.3.2 Removing and installing brake booster, left-hand drive
with Bi-Turbo diesel engine", page 96
⇒ "3.3.3 Removing and installing brake servo, right-hand drive
with diesel engine", page 98
⇒ "3.3.4 Removing and installing brake servo, right-hand drive
with petrol engine", page 100
3.3.1 Removing and installing brake booster,
left-hand drive, except for Bi-Turbo die‐
sel engine
Special tools and workshop equipment required
♦ Brake filling and bleeding device , e. g. -VAS 5234-
♦ Extraction bottle (commercially available)
♦ Repair kit - 1H0 698 311 A-
Removing
– By pressing the brake pedal several times, eliminate the vac‐
uum in the brake servo unit.
– Remove master brake cylinder
⇒ "3.4 Removing and installing master brake cylinder",
page 102 .
– Pull vacuum hose out of brake servo.
– Remove knee airbag ⇒ Interior body work; Rep. gr. 69 ; Knee
airbags; removing and installing knee airbag with ignition
– Remove the left footwell vent ⇒ Heating system, air condi‐
tioning system; Rep. gr. 87 ; Air duct; Remove and install
driver side footwell vent .
– Separate brake pedal from brake servo
⇒ "4.3 Separating brake pedal from brake servo", page 79
Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
.
3. Brake servo unit and master brake cylinder
95