Removing And Installing Control Unit - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
– Press on cardan shaft flange.
– Then screw in new nut using locking agent - D 000 600- and
tighten.
A - Screw M10 x 25
B - Allen screw M8 x 15 (is screwed in from the reverse side into
the counterholder - T30004- )
C - Counterholder - T30004-
– Install four-wheel drive clutch
⇒ "6.8.1 Removing and installing generation II four-wheel drive
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
clutch, final drive 02D, 0AV, Octavia II", page 115
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
– Install propshaft at rear final drive
⇒ "1.3 Removing and installing propshaft", page 26
– Install exhaust system and align free of stress ⇒ Engine; Rep.
gr. 26 .
– Check the oil level in the four-wheel drive clutch, top up with
oil if necessary
⇒ "6.4 Checking oil level in the four-wheel drive clutch",
page 106 .
6.10

Removing and installing control unit

⇒ "6.10.1 Removing and installing generation II four-wheel drive
clutch control unit, final drive 02D, 0AV, Octavia II", page 134
⇒ "6.10.2 Removing and installing generation IV four-wheel drive
clutch control unit, final drive 0BR, Octavia II, Superb II, Yeti, up
to 10/2013", page 137
⇒ "6.10.3 Removing and installing V generation four-wheel drive
clutch control unit, Yeti, from 11/2013", page 139
6.10.1 Removing and installing generation II
four-wheel drive clutch control unit, final
drive 02D, 0AV, Octavia II
Special tools and workshop equipment required
♦ Catch pan
134
Rep. gr.39 - Final drive - rear differential
.
.