Removing And Installing Brake Pads, Front Brake - Skoda Kodiaq 2017 Workshop Manual

9 - Screw
❑ clean when using again
❑ 200 Nm
10 - Wheel bearing housing
❑ with bolted brake carrier
❑ Assignment ⇒ Electronic Catalogue of Original Parts
11 - Brake hose
❑ with banjo union and hollow screw
❑ pay attention to correct installation position
❑ 35 Nm
12 - Retaining clip
13 - Support
14 - Screw
❑ 8 Nm
1.2 Removing and installing brake pads,
front brake
⇒ "1.2.1 Changing the brake pads of the front brake - Mounting
instructions", page 47
⇒ "1.2.2 Removing and installing brake pads, front brake",
page 47
1.2.1 Changing the brake pads of the front
brake - Mounting instructions
When changing the pads, pay attention to the following points:
– Check protective collar of brake calliper piston.
Replace protective cap if damaged.
When replacing the protective cap:
– Check the contact surfaces of the brake piston and the brake
caliper for any dirt (oxidation).
Carefully clean the piston as well as the brake caliper if dirty and
replace the sealing cap.
– Check the brake piston and the brake caliper (corrosion,
grooves on the outside of the cylinder surface), replace the
brake caliper completely if damaged.
For brake caliper piston, press into the initial position:
– Check if the piston can be slightly pressed into the brake cal‐
iper.
If the piston cannot be slightly pressed into the brake caliper:
– Check and clean the brake piston as well as the brake caliper,
replace sealing sleeve and protective cap.
Replace the brake caliper completely if damaged.
1.2.2 Removing and installing brake pads,
front brake
Special tools and workshop equipment required
♦ Piston jig - T10145-
Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
47
1. Front brakes