Removing And Installing Selector Lever Control Cable, Vehicles Up To - Skoda FABIA II 2007 Workshop Manual

– Carefully press the selector lever control cable -2- onto the
gearshift lever and secure in the cable support with a new lock
washer -1-.
– Check the function of the ignition key anti-removal lock
⇒ "2.4 Check the function of the ignition key removal lock",
page 108 .
– Setting selector lever control cable
⇒ "2.3 Inspecting and adjusting the selector lever control ca‐
ble", page 105 .
– Install air filter ⇒ Engine; Rep. gr. 24 or ⇒ Engine; Rep. gr.
23 .
– Inspect gearshift mechanism
⇒ "2.2 Inspecting the gearshift mechanism", page 104
– Install the heat shield below the shift mechanism and fasten
the trim panels for the underfloor on the body ⇒ Body Work;
Rep. gr. 50 .
– Install exhaust system and align free of stress ⇒ Engine; Rep.
gr. 26 .
– Install the tunnel bridges below the exhaust system ⇒ Engine;
Rep. gr. 26 .
Specified torques
♦ ⇒ "2.1 Summary of components - Gearshift mechanism", page
97
2.9 Removing and installing selector lever
control cable, vehicles up to 05.2009
(Octavia II, Superb II, Yeti)
Special tools and workshop equipment required
♦ Removal tool for the inner lining of the door panel -MP8-602/1-
The selector lever control cable was replaced as a separate com‐
ponent part up to production date 05.2009
⇒ "2.1.1 Summary of components - Gearshift mechanism up to
05.2009 - (Octavia II, Superb II, Yeti)", page 97
As of production date 06.2009, this is no longer possible. The
selector lever control cable must not be removed (separated) from
the shift mechanism and must be replaced together as one com‐
ponent part ⇒ Electronic Catalogue of Original Parts .
Removing
– Shift selector lever into position S.
– Switch off ignition.
– Remove air filter ⇒ Engine; Rep. gr. 24 or ⇒ Engine; Rep.
gr. 23 .
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
.
Gearbox 0AM-DSG - Edition 01.2015
.
123
2. Shift mechanism