Removing And Installing Brake Pads - Skoda Kodiaq 2017 Workshop Manual

Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
❑ Observe the instructions for changing the pad
⇒ "2.2.1 Changing the brake pads of the rear brake - Mounting instructions", page 58
11 - Spring
❑ Only on inner brake pad
❑ Check fitting position
12 - Brake line
❑ 14 Nm
13 - Brake line holder
14 - Safety device
15 - Brake hose
❑ with banjo union and hollow screw
❑ To the brake calliper: 35 Nm
❑ To the brake line: 14 Nm
16 - Guide bolt
❑ 35 Nm
17 - Cover caps
18 - Sealing ring
❑ for handbrake motor
❑ Replace after disassembly
19 - Screw
❑ 8 Nm
20 - Handbrake motor -V282- / -V283-
❑ Removing and installing
2.2

Removing and installing brake pads

⇒ "2.2.1 Changing the brake pads of the rear brake - Mounting
instructions", page 58
⇒ "2.2.2 Removing and installing brake pads, rear brake",
page 59
2.2.1 Changing the brake pads of the rear
brake - Mounting instructions
When changing the pads, pay attention to the following points:
– Check protective collar of brake calliper piston.
Replace protective cap if damaged.
When replacing the protective cap:
– Check the contact surfaces of the brake piston and the brake
caliper for any dirt (oxidation).
Carefully clean the piston as well as the brake caliper if dirty and
replace the sealing cap.
– Check the brake piston and the brake caliper (corrosion,
grooves on the outside of the cylinder surface), replace the
brake caliper completely if damaged.
For brake caliper piston, press into the initial position:
– Check if the piston can be slightly pressed into the brake cal‐
iper.
If the piston cannot be slightly pressed into the brake caliper:
58
Rep. gr.46 - Brakes - mechanism
⇒ "3.3 Removing and installing handbrake motor V282 / V283 ", page 69