Reviewing Results Of The Q-Vet Run - Compaq AlphaServer ES45 Service Manual

2.4.3

Reviewing Results of the Q-Vet Run

After running Q-Vet, check the results of the run by reviewing the
summary log.
If you follow the above steps, Q-Vet will run all exercisers until the slowest
device has completed one full pass. Depending on the size of the system
(number of CPUs and disks), this will typically take 2 to 12 hours. Q-Vet will
then terminate testing and produce a summary log. The termination message
will tell you the name and location of this file.
All exerciser processes can also be manually terminated with the Suspend and
Terminate buttons (stop and terminate commands).
After all exercisers report "Idle," the summary log is produced containing Q-Vet
specific results and statuses.
A. If there are no Q-Vet errors, no system event appendages, and testing
ran to the specified completion time, the following message will be
displayed:
"Q-Vet Tests Complete: Passed"
B. Otherwise, a message will indicate:
"Additional information may be available from Compaq
Analyze"
It is recommended that you run Compaq Analyze to review test results. The
testing times (for use with Compaq Analyze) are printed to the Q-Vet run
window and are available in the summary log.
Troubleshooting 2-17