Power-Up Error Messages; Srom Messages With Beep Codes - Compaq AlphaServer ES45 Service Manual

3.4

Power-Up Error Messages

Error messages at power-up may be displayed by the RMC, SROM, and
SRM. A few SROM messages are announced by beep codes.
3.4.1

SROM Messages with Beep Codes

Table 3–1 Error Beep Codes
Beep Associated
Code Messages
1 Jump to
Console
1-1-4 ROM err
2-1-2 Cfg ERR n
Cfg ERR s
3-14 ES45 Service Guide
Meaning
SROM code has completed execution. System jumps to
SRM console. SRM messages should start to be
displayed. If no SRM messages are displayed, it may
indicate corrupted firmware. See Section 3.4.2.
The ROM err message is displayed briefly, then a single
beep is emitted, and Jump to Console is displayed. The
SROM code is unable to load the console code; a flash
ROM header area or checksum error has been detected.
See Section 3.4.2.
Configuration error on CPU n (n is 0, 1, 2, or 3) or a
system configuration error. The system will still power
up.