Table of Contents
Advertisement
CAUTION: Always plug the cables into the cage that is on the same side as the
cage that was removed.
9. Partially slide the drive cage
10. Connect the power source
11. Attach the 10-pin cable
12. Slide the cage in the rest of the way and attach it with the four screws set
aside previously.
13. Replace fans 3 and 4 (if removed previously), PCI card cage cover, and en-
closure panels.
14. Install disk drives.
CAUTION: Disk drives must be installed from left to right. Otherwise, the sys-
tem will not find the system disk.
13. Plug in the power cords.
Verification
1. Turn on power to the system.
2. At the P00>>> prompt, enter the SRM show device command to display
the devices and controllers in the system. The list should include the SCSI
controller and disk drives that you installed.
8-48
ES45 Service Guide
into the system chassis.
(located inside enclosure) to the drive cage.
and 68-pin cable
to the drive cage.
Advertisement
Table of Contents
Troubleshooting
