Table of Contents
Advertisement
!
WARNING: To prevent injury, access is limited to persons who
have appropriate technical training and experience. Such per-
sons are expected to understand the hazards of working within
this equipment and take measures to minimize danger to them-
selves or others.
WARNING: To prevent injury, unplug the power
cord from each power supply before installing com-
ponents.
!
WARNING: Modules have parts that operate at high
temperatures. Wait 2 minutes after power is removed
before touching any module.
1. Shut down the operating system and turn off power to the system. Unplug
the power cord from each power supply.
2. Remove the cover to the PCI card cage area.
3. Unplug the signal and power cables to the CD.
4. Remove and set aside the four screws
cage.
CAUTION: Be careful not to tangle the wires to the CD-ROM and floppy.
5. Slide the cage out far enough to gain access to the floppy cables. Unplug the
cables and remove the cage.
6. Remove a blank storage panel
from behind the panel. If you are installing a full-height device, remove two
panels.
7. Remove the divider plate
the plate and bending it sufficiently to free it from the slots.
8. Set the SCSI ID on the device as desired.
securing the removable media
for the desired storage slot by pushing
between the two slots by pressing the center of
FRU Removal and Replacement
8-51
Advertisement
Table of Contents
Troubleshooting
