Compaq AlphaServer ES45 Service Manual page 335

Table A–1 SRM Commands Used on ES45 Systems (Continued)
Command
rmc
set envar
set sys_serial_num
show envar
show config
show device
show error
show fru
show memory
show pal
show power
show_status
show version
sys_exer
sys_exer -lb
test
test -lb
Function
Invokes the remote management console from the local VGA
monitor.
Sets or modifies the value of an environment variable.
Sets the system serial number.
Displays the state of the specified environment variable.
Displays the logical configuration at the last system
initialization.
Displays a list of controllers and bootable devices in the
system.
Reports errors logged in the FRU EEPROMs.
Displays information about field replaceable units (FRUs).
Displays information about system memory.
Displays the versions of Tru64 UNIX and OpenVMS PALcode.
Displays information about system environmental
characteristics, including power supplies, system fans, CPU
fans, and temperature.
Displays the progress of diagnostic tests. Reports one line of
information for each executing diagnostic.
Displays the version of the SRM console program installed on
the system.
Exercises the devices displayed with the show config command
Runs console loopback tests for the COM2 serial port and the
parallel port during the sys_exer test sequence.
Verifies the configuration of the devices in the system.
Runs loopback tests for the COM2 serial port and the parallel
port in addition to verifying the configuration of devices.
SRM Console Commands A-3