7.6.6
Configuring Remote Dial-In
Before you can dial in through the RMC modem port or enable the
system to call out in response to system alerts, you must configure
RMC for remote dial-in.
Connect your modem to the 9-pin modem port and turn it on. Connect to the
RMC CLI from either the local serial terminal or the local VGA monitor to set
up the parameters.
Example 7–8 Dial-In Configuration
RMC> set password
RMC Password: ****
Verification: ****
RMC> set init
Init String: AT&F0E0V0X0S0=2
RMC> enable remote
RMC> status
.
.
Remote Access: Enabled
.
.
.
7-24
ES45 Service Guide