7.5
SRM Environment Variables for COM1
Several SRM environment variables allow you to set up the COM1
serial port (MMJ) for use with the RMC.
You may need to set the following environment variables from the SRM console,
depending on how you decide to set up the RMC.
com1_baud
com1_flow
com1_mode
com1_modem
7-12
ES45 Service Guide
Sets the baud rate of the COM1 serial port and the
modem port. The default is 9600.
Specifies the flow control on the serial port. The
default is software.
Specifies the COM1 data flow paths so that data
either flows through the RMC or bypasses it. This
environment variable can be set from either the SRM
or the RMC.
Specifies to the operating system whether or not a
modem is present.