Table of Contents
Advertisement
1. Shut down the operating system and turn off power to the system. Unplug
the power cord from each power supply.
2. Access the system chassis by following the instructions in Section 8.2 or 8.3.
3. Remove the covers from the fan area and the system card cage as explained
in Section 8.4.
4. When adding a CPU module, install it in the next lowest numbered slot
available (See Figure 8–13).
5. When adding a CPU module, remove and discard the airflow deflector plate
from the CPU slot.
6. Insert the CPU card
simultaneously.
7. Replace the system card cage cover, fan cover, and enclosure covers.
8. Reconnect the power cords.
Verification
1. Turn on power to the system.
2. During power-up, observe the screen display. The newly installed CPU
should appear in the display.
3. Issue the show config command to display the status of the new CPU.
8-32
ES45 Service Guide
into the connector and push down on both latches
Advertisement
Table of Contents
Troubleshooting
