Table of Contents
Advertisement
7.6.8
Resetting the Escape Sequence
The RMC set escape command sets a new escape sequence.
The new escape sequence can be any character string, not to exceed 14
characters. A typical sequence consists of two or more control characters. It is
recommended that control characters be used in preference to ASCII characters.
Use the status command to verify the new escape sequence before exiting the
RMC.
The following example consists of two instances of the Esc key and the letters
"FUN." The "F" is not displayed when you set the sequence because it is
preceded by the escape character. Enter the status command to see the new
escape sequence.
Example 7–10 set escape
RMC> set escape
Escape Sequence: un
RMC> status
.
.
.
Escape Sequence: ^[^[FUN
CAUTION: Be sure to record the new escape sequence. Restoring the default
sequence requires moving a jumper on the system motherboard.
Using the Remote Management Console
7-29
Advertisement
Table of Contents
Troubleshooting
