Compaq AlphaServer ES45 Service Manual page 66

OpenVMS
1. Delete any QVETAXPxxx.A or QVETAXPxxx.EXE file from the current
directory.
2. Copy the self-extracting kit image file (QVETAXPxxx.EXE) to the current
directory.
3. It is highly recommended, but not required, that you purge the system disk
before installing Q-Vet. This will free up space that may be needed for
pagefile expansion during the AUTOGEN phase.
$purge sys$sysdevice:[*...]*.*
4. Extract the kit saveset with the command $run QVETAXPxxx.EXE and
verify that the kit saveset was extracted by checking for the "Successful
decompression" message.
5. Use @sys$update:vmsinstal for the Q-Vet installation. The installation
will size your system for devices and memory. You should choose all the
default answers during the Q-Vet installation. This will verify the Q-Vet
installation, tune the system, and reboot. During the install, if you do not
intend to use the GUI, you can answer no to the question "Do you want to
install Q-Vet with the DECwindows Motif interface?"
6. After the installation completes you should delete the QVETAXP0xx.A file
and the QVETAXPxxx.EXE file.
7. On reboot you can start Q-Vet GUI via $vet or the command interface via
$vet/int=char.
2-14 ES45 Service Guide