Compaq AlphaServer ES45 Service Manual page 299

!
WARNING: To prevent injury, access is limited to per-
sons who have appropriate technical training and ex-
perience. Such persons are expected to understand
the hazards of working within this equipment and take
measures to minimize danger to themselves or others.
!
WARNING: Modules have parts that operate at high
temperatures. Wait 2 minutes after power is removed
before touching any module.
WARNING: To prevent injury, unplug the power
cord from each power supply before installing com-
ponents.
1. Shut down the operating system and turn off power to the system. Unplug
the power cord from each power supply.
2. Access the system chassis by following the instructions in Section 8.2,
Removing Enclosure Panels.
3. Remove the fan cover and the system card cage cover.
4. Use Figure 8–16 or Figure 8–17 to determine where sets of memory DIMMs
should be installed. Begin with the next available lowest numbered set.
5. Release the clips
MMB.
securing the appropriate MMB
FRU Removal and Replacement
and slide out the
8-35