Agilent Technologies N9360A Programming Manual page 71

N9360A Multi UE Tester W-CDMA Programming Manual
CONFigure:SEQuence:LOSS:RFOUT:CHANnel3 <<
<real 1>,<real 2>,<real 3>,<real 4>,<<
<real 5>,<real 6>
CONFigure:SEQuence:LOSS:RFOUT:CHANnel3?
CONFigure:SEQuence:LOSS:RFOUT:CHANnel4 <<
<real 1>,<real 2>,<real 3>,<real 4>,<<
<real 5>,<real 6>
CONFigure:SEQuence:LOSS:RFOUT:CHANnel4?
CONFigure:SEQuence:LOSS:RFOUT:CHANnel5 <<
<real 1>,<real 2>,<real 3>,<real 4>,<<
<real 5>,<real 6>
CONFigure:SEQuence:LOSS:RFOUT:CHANnel5?
CONFigure:SEQuence:LOSS:RFOUT:CHANnel6 <<
<real 1>,<real 2>,<real 3>,<real 4>,<<
<real 5>,<real 6>
CONFigure:SEQuence:LOSS:RFOUT:CHANnel6?
This command sets the RF output path loss on each RFCH,
<real 1> Band 1 and <real 6> Band 6, respectively. <real
2>, <real 3>, <real 4> and <real 5> are unused (Set to
). The allowable range is from
0.0
preset, this is set to
0.0
This query command returns the setting of the RF output path
loss on each channel with real. Each value is separated by a
comma. The range of the values is same as that of the command
parameter.
Location Update
CONFigure:SEQuence:SIGNaling: <<
LOCUpdate OFF|LU1|LU2
CONFigure:SEQuence:SIGNaling:LOCUpdate?
Programming Command Reference
to
-9.9 +9.9
.
5
in steps. At
0.1
5-25