Agilent Technologies N9360A Programming Manual page 38

4
Programming Command Guidelines
4-12
Else, proceed to the next step.
Step 7
Start the measurement.
<Send Command to the Tester> TRIG:IMM
Step 8
To read the measurement results, wait until the measurement
ends.
<Send Query Command to the Tester> *STB?
If the Response is not
Else, proceed to the next step.
Step 9
Read the test results of Peak TX Power, for example as follows:
<Send Query Command to the Tester> TEST:MAN:RES:TXP?
<Display Message on the PC> Peak TX Power :<Value 3> dBm
<Display Message on the PC>
If the <Value 2> is not 0, Message is FAIL.
Else, Message is PASS.
Step 10
Start the BS Release, for example as follows:
<Send Command to the Tester> TEST:MAN:BSR
<Send Query Command to the Tester> TEST:MAN:SIGN:STAT?
If the Response is not
Else, complete the test.
N9360A Multi UE Tester W-CDMA Programming Manual
, resend the query.
0
, resend the query.
16