Programming Command Guidelines - Agilent Technologies N9360A Programming Manual

4

Programming Command Guidelines

< Send Command to the Tester> APPL:WCDMA
Step 3
Configure test setting on the [Configuration] screen.
< Send Command to the Tester> CONF:LOSS ON
< Send Command to the Tester> CONF:LOSS:RFIN
0.5,0.5,0.5,0.5
< Send Command to the Tester> CONF:LOSS:RFOU
1.0,1.0,1.0,1.0
<Send Command to the Tester> CONF:COND:BAND 1
<Send Command to the Tester> CONF:COND:3GPP 2
Step 4
Configure test setting on a test mode screen. For example, the
Manual Test mode test sets as follows:
<Send Command to the Tester> TEST:MAN:RFCH:CHAN 9800
<Send Command to the Tester> TEST:MAN:BSCT RMC
Step 5
Create an instruction message as follows for the operator to
turn on the mobile phone and wait until the Location Update to
complete.
<Display Message on the PC screen> Turn on the mobile phone
and wait until [P] is shown at the [Location Update]. Then
press [OK] button.
<Wait until the OK button on the PC screen is clicked on>
Step 6
Start the BS Call, and then check that the test flow changes to
the Talk/RF Test step.
< Send Command to the Tester> TEST:MAN:BSC
<Send Query Command to the Tester> TEST:MAN:SIGN:STAT?
If the Response is not , resend the query.
2
N9360A Multi UE Tester W-CDMA Programming Manual 4-11