Agilent Technologies N9360A Programming Manual page 52

5
Programming Command Reference
NOTE
5-6
MAN:STBY = [Manual Test : Stand-by] Screen
MAN:SMS: [Manual Test : Stand-by] SMS Screen
TXAN:STBY = [TX Analyzer : Stand-by] Screen
RFG = [Signal Generator] Screen
CONF = [Configuration] Screen
CONF:COND = [Configuration : Test Condition] Screen
CONF:SEQ = [Configuration : Test Sequence] Screen
CONF:FILE = [Configuration : File Management] Screen
ELSE = The other screens
• <int> when the [Automatic Test : Stand-by] screen is
currently displayed, the Sequence number, 1 or 2, is
displayed. When other screen is displayed, 0 is returned.
Top Menu Screen
DISPlay:INIT
This command selects the [Top Menu] screen for activating one
of the function modes.
System Configuration
DISPlay:CONFigure
This command selects the [Configuration] screen. The
parameters and controls on this screen set the fundamental
information for all function modes of the Tester.
Parameters of Serial Port, GP-IB and Ethernet are not programmable but
manually settable.
Application Type
DISPlay:APPLication?
This command returns a type of current active application.
N9360A Multi UE Tester W-CDMA Programming Manual