Agilent Technologies N9360A Programming Manual page 63

N9360A Multi UE Tester W-CDMA Programming Manual
This command specifies the Band in order to set each BS Level
on each band. The parameter is
BS Level
CONFigure:SEQuence:AMPLitude <real>
CONFigure:SEQuence:AMPLitude?
This command specifies the amplitude (BS Level) in each band
set by the Band command described above. The allowable range
is from to
-110.0 -20.0
set to (dBm).
-65.7
Measurement BS Level
CONFigure:SEQuence:MEASurementbslevel <real>
CONFigure:SEQuence:MEASurementbslevel?
This command specifies the amplitude (BS Level) for MAX TX
Power, Inner Loop Power, EVM and Origin Offset measurement in each
band set by the Band
range is from
-110.0
this is set to (dBm).
-93.0
Openloop BS Level (Open Loop TX Power BS Level)
CONFigure:SEQuence:OLPbslevel <real>
CONFigure:SEQuence:OLPbslevel?
This command specifies the amplitude (BS Level) for
measurement in each band set by the
on page 16. The allowable range is from
in steps. At preset, this is set to
0.1
BER BS Level
CONFigure:SEQuence:BERbslevel <real>
CONFigure:SEQuence:BERbslevel?
Programming Command Reference
or . At preset, this is set to
1 6
(dBm) in steps. At preset, this is
0.1
command described above. The allowable
to (dBm) in
-20.0 0.1
Band
-110.0
-65.7
5
.
1
steps. At preset,
command described
to (dBm)
-20.0
(dBm).
5-17