Agilent Technologies N9360A Programming Manual page 113

5
Programming Command Reference
: Outputs (without S-CCPCH), RMC
IDLE+DPCH(PN9)+OCNS IDLE
12.2kbps(PN9) and OCNS.
: Outputs (without S-CCPCH),
IDLE+DPCH(PN15)+OCNS IDLE
RMC 12.2kbps(PN15) and OCNS.
This is automatically set to when the screen is changed to
IDLE
the [TX Analyzer] screen while Modulation on the [Signal
Generator] screen is set to . (There is no setting in TX
OFF OFF
Analyzer.)
This query command returns the set modulation.
RF Signal Output
TXANalyzer:RFOUtput ON|OFF|1|0
TXANalyzer:RFOUtput?
This command sets RF Signal Output status. The parameter is
(1) or (0). At preset, this is set to . This works with RF
ON OFF OFF
Output on the [Signal Generator] screen.
Averaging
TXANalyzer:AVERage OFF|<int>
TXANalyzer:AVERage?
This command sets whether or not to activate the averaging.
The parameter is or <int> for the number of averaging
OFF
times. The allowable range of <int> is from to . At preset,
2 99
this is set to .
OFF
This query command returns the set averaging.
TX Power Measurement
TXANalyzer:TXPower:STATe ON|OFF|1|0
TXANalyzer:TXPower:STATe?
This command sets whether or not to execute the TX Power
measurement. The parameter is (1) or (0). At preset, this
ON OFF
is set to .
ON
N9360A Multi UE Tester W-CDMA Programming Manual 5-67