Agilent Technologies N9360A Programming Manual page 70

5
Programming Command Reference
5-24
<real 5>,<real 6>
CONFigure:SEQuence:LOSS:RFIN:CHANnel4?
CONFigure:SEQuence:LOSS:RFIN:CHANnel5 <<
<real 1>,<real 2>,<real 3>,<real 4>,<<
<real 5>,<real 6>
CONFigure:SEQuence:LOSS:RFIN:CHANnel5?
CONFigure:SEQuence:LOSS:RFIN:CHANnel6 <<
<real 1>,<real 2>,<real 3>,<real 4>,<<
<real 5>,<real 6>
CONFigure:SEQuence:LOSS:RFIN:CHANnel6?
This command sets the RF input path loss on each RFCH,
<real 1> Band 1 and <real 6> Band 6, respectively. <real
2>, <real 3>, <real 4> and <real 5> are unused (Set to
). The allowable range is from
0.0
preset, this is set to
0.0
This query command returns the setting of the RF input path
loss on each channel with real. Each value is separated by a
comma. The range of the values is same as that of the command
parameter.
RF Output Attenuation
CONFigure:SEQuence:LOSS:RFOUT:CHANnel1 <<
<real 1>,<real 2>,<real 3>,<real 4>,<<
<real 5>,<real 6>
CONFigure:SEQuence:LOSS:RFOUT:CHANnel1?
CONFigure:SEQuence:LOSS:RFOUT:CHANnel2 <<
<real 1>,<real 2>,<real 3>,<real 4>,<<
<real 5>,<real 6>
CONFigure:SEQuence:LOSS:RFOUT:CHANnel2?
N9360A Multi UE Tester W-CDMA Programming Manual
to
-9.9 +9.9
.
in steps. At
0.1