Command Reference For Configuration : Test Sequence Screen - Agilent Technologies N9360A Programming Manual

5
Programming Command Reference

Command Reference for Configuration : Test Sequence Screen

5-16
The sequence commands are used to control the test flow, test
sequences of Automatic Test, and also to define whether to
execute the pass or fail tests at the specified RFCH. The query
commands return the settings of those controls and parameters.
Radio System
CONFigure:SEQuence:RFORmat W-CDMA|OFF
CONFigure:SEQuence:RFORmat?
This command selects a Radio System to be tested. The
parameter is W-CDMA or OFF. At preset, this is set to W-CDMA.
This query command returns the selected Radio System with
strings.
Sequence Number
CONFigure:SEQuence:NO 1|2
CONFigure:SEQuence:NO?
This command specifies a sequence number. The sequence
number specified here applies to the commands that relate to
sequence. At preset, this is set to
This query command returns the selected Sequence Number
with integer value of 1 or 2.
Band
CONFigure:SEQuence:BAND <int>
CONFigure:SEQuence:BAND?
This command specifies the Band in order to set each BS Level
on each band. The parameter is
This command works on the same principle as
CONFigure:SEQuence:BSLEvel:BAND.
This command will be eliminated in future. (This is remained
for convenience of existing users.)
CONFigure:SEQuence:BSLEvel:BAND <int>
CONFigure:SEQuence:BSLEvel:BAND?
N9360A Multi UE Tester W-CDMA Programming Manual
.
1
or . At preset, this is set to
1 6
.
1