Table 5-16 Frequency Allowable Range And Preset Value - Agilent Technologies N9360A Programming Manual

5
Programming Command Reference
5-74
This query command returns the set frequency of the RFCH
with real. The range of the value is same as that of the command
parameter.
RFGenerator:FREQuency <int 1>,<real 2>
RFGenerator:FREQuency?
This command sets a Band and frequency for RF (downlink) on
Stand-by screen.
<int 1> is a Band and set to
frequency (downlink frequency) and set to
preset. The allowable ranges are as follows:

Table 5-16 Frequency Allowable Range and Preset Value

Band Allowable Range [Hz]
1 2110000000 to 2170000000 in 2000 steps
6 875000000 to 885000000 in 2000 steps, 877500000, 882500000
At start up of the Tester, the queries in <int 1> and <int 2>
format are returned.
If the setting with <int> format is performed, the format of the
query changes to <int> format.
If the setting with <int 1> and <int 2> format is performed,
the format of the query returns to <int 1> and <int 2>
format.
This query command returns the set Band and Frequency of
RFCH with real. The range of the value is same as that of the
command parameter.
Amplitude
RFGenerator:AMPLitude <real>
RFGenerator:AMPLitude?
This command sets the amplitude of the Tester applied to the
mobile phone under test. The allowable range is from
(dBm) in steps. At preset, this is set to
-20.0 0.1
This query command returns the set output amplitude with
real. The range of the value is same as that of the command
parameter.
N9360A Multi UE Tester W-CDMA Programming Manual
at preset. <int 2> is a
1
2112400000
-50.0
at
to
-110.0
(dBm).