Agilent Technologies N9360A Programming Manual page 75

N9360A Multi UE Tester W-CDMA Programming Manual
This command sets the amplitude (BS Level) in each Band. The
allowable range is from
preset, this is set to
-50.0
This query command returns the set amplitude with real. The
range of the value is same as that of the command parameter.
BER Frame
CONFigure:CONDition:SENSitivity:FRAMe <int>
CONFigure:CONDition:SENSitivity:FRAMe?
This command sets the number of the frames for bit error ratio
(BER) tests. The allowable range is from
step. At preset, this is set to
This query command returns the set number of the frames for
BER test with integer. The range of the value is same as that of
the command parameter.
Open Loop TX Power
CONFigure:CONDition:LIMit:OPENpower <<
<real LO>,<real HI>
CONFigure:CONDition:LIMit:OPENpower?
This command sets the low and high limits for the test in each
band set by the Band
allowable range is from
preset, this is set to
-24.0
This query command returns the set low and high limits of the
test with real separated by a comma. The range of the value is
same as that of the command parameter.
Inner Loop Power (DownMin)
CONFigure:CONDition:LIMit:INNErpower:<<
DownMIN <real LO>,<real HI>
CONFigure:CONDition:LIMit:INNErpower:DownMIN?
Programming Command Reference
to (dBm) in
-110.0 -20.0
(dBm).
to
1
.
10
command described on
to (dBm) in
-99.9 +99.9
(dBm) and
-4.0
5
steps. At
0.1
(frames) in
4100 1
page 28. The
steps. At
0.1
(dBm).
5-29