Table 7-6 Program Comments - Agilent Technologies N9360A Programming Manual
Multi ue tester
Hide thumbs
Also See for N9360A:
- Programming manual (352 pages) ,
- Installation manual (46 pages) ,
- Quick reference manual (44 pages)
Table of Contents
Advertisement
7
Sample Program
Table 7-6 Program Comments
Row
Description
2:
Declares the variable to store test results.
4:
Erases the status field.
7:
Queries the manufacturer, model number, serial number and revision number of the firmware.
8-11:
Displays the manufacturer, model number, serial number and revision number of the firmware on the status field.
13:
Resets the Tester to the default setting for programming.
16:
Activates the Loss correction function.
17:
Sets the Loss RF IN field.
18:
Sets the Loss RF OUT field.
19:
Sets the Averaging.
20:
Sets the Amplitude (BS Level).
21:
Sets the 3GPP System.
24:
Sets the Modulation to IDLE.
25:
Sets the RF OUTPUT to ON.
29:
Sets the Band and RFCH.
29:
Starts the measurement.
30:
Waits until the measurement is completed.
31:
Queries the measurement result of TX Power.
32:
Displays the measurement value and judgment result of TX Power in the status field.
33:
Queries the measurement result of Frequency Error.
34:
Displays the measurement value and judgment result of Frequency Error in the status field.
35:
Queries the measurement result of EVM.
36:
Displays the measurement value and judgment result of EVM in the status field.
37:
Queries the measurement result of Origin Offset.
38:
Displays the measurement value and judgment result of Origin Offset in the status field.
40:
Displays Complete message in the status field.
7-16
N9360A Multi UE Tester W-CDMA Programming Manual
Advertisement
Table of Contents
