Agilent Technologies N9360A Programming Manual page 49

N9360A Multi UE Tester W-CDMA Programming Manual
Standard Event Status Enable
*ESE <int>
*ESE?
This command sets or queries a value of the Standard Event
Status Enable Register (SESER). The allowable range is from
to . For detailed information, refer to
255
Enable Register on page
Event Status Register Query
*ESR?
This query command returns a value of the Standard Event
Status Register (SESR). The range of a value is from
Information contained in the Standard Event Status Register is
as follows:
bit 0 (1): Operation Complete
bit 1 (2): Unused
bit 2 (4): Query Error
bit 3 (8): Device Dependent Error
bit 4 (16): Execution Error
bit 5 (32): Command Error
bit 6 (64): Unused
bit 7 (128): Power On
For detailed information, refer to
Register on page 16.
Status Byte Register Query
*STB?
This query command returns a value of the Status Byte Register
(STBR). The range of a value is from
contained in the Status Byte Register is as follows:
bit 0 (1): Measurement Data Ready
bit 1 (2): Measuring Status
bit 2 (4): Unused
Programming Command Reference
Standard Event Status
18.
Standard Event Status
to . Information
0 255
5
0
to .
0 255
5-3