Agilent Technologies N9360A Programming Manual page 65

N9360A Multi UE Tester W-CDMA Programming Manual
This command specifies the wait time before paging
transmission in Automatic Test. The allowable range is from
to (seconds) in
99.9 0.1
The query command returns the setting of wait time before
paging transmission with integer.
RFCH
CONFigure:SEQuence:VARiable:RFCH:CHANnel1 <int
1>,<int 2>
CONFigure:SEQuence:VARiable:RFCH:CHANnel1?
CONFigure:SEQuence:VARiable:RFCH:CHANnel2 <int
1>,<int 2>
CONFigure:SEQuence:VARiable:RFCH:CHANnel2?
CONFigure:SEQuence:VARiable:RFCH:CHANnel3 <int
1>,<int 2>
CONFigure:SEQuence:VARiable:RFCH:CHANnel3?
CONFigure:SEQuence:VARiable:RFCH:CHANnel4 <int
1>,<int 2>
CONFigure:SEQuence:VARiable:RFCH:CHANnel4?
CONFigure:SEQuence:VARiable:RFCH:CHANnel5 <int
1>,<int 2>
CONFigure:SEQuence:VARiable:RFCH:CHANnel5?
CONFigure:SEQuence:VARiable:RFCH:CHANnel6 <int
1>,<int 2>
CONFigure:SEQuence:VARiable:RFCH:CHANnel6?
These commands set a Band and a variable (uplink channel number) for
RFCH. The measurement on the RFCH is skipped if these are set to
(— is shown in the table cell). RFCH1 cannot be skipped. <int
99999
1> is a band and <int 2> is a variable. The allowable range and
preset values are as follows:
Programming Command Reference
steps. At preset, this is set to
5
0.0
.
0.0
,
-1
5-19