Agilent Technologies N9360A Programming Manual page 115

N9360A Multi UE Tester W-CDMA Programming Manual
OBW
TXANalyzer:OBW:STATe ON|OFF|1|0
TXANalyzer:OBW:STATe?
This command sets whether or not to execute the OBW
measurement. The parameter is
is set to . This command is valid only when the W07 option is
ON
installed in the Tester. If the W07 option is not installed in the
Tester, an execution error occurs.
This query command returns the setting of the OBW
measurement. The meaning of the return value is same as that
of the command parameter.
TX Power Measurement
TXANalyzer:RESults:TXPower?
This query command returns the TX Power measurement result
values, <int 1>, <int 2>, and <real 3>. Each value is
separated by a comma.
• <int 1> (1 digit) is
measurement range, or
range or TX Power is not measured.
• <int 2> (1 digit) is the test result for the pass (0) or fail (1).
• <real 3> (up to 6 letters) is the measured data ranging
from to
-99.99 +99.99
of range or TX Power is not measured, the value
returned.
Frequency Error Measurement
TXANalyzer:RESults:FREQuency?
This query command returns the Frequency Error
measurement result values, <int 1>, <int 2>, and <real 3>.
Each value is separated by a comma.
• <int 1> (1 digit) is
measurement range, or
range or Frequency Error is not measured.
• <int 2> (1 digit) is the test result for the pass (0) or fail (1).
Programming Command Reference
(1) or
ON OFF
if measurement result is within the
0
if measurement result is out of
1
in dBm. If measurement range is out
if measurement result is within the
0
if measurement range is out of
1
5
(0). At preset, this
is
-99.99
5-69