Configuration Screen; System Configuration Screen; Table 6-4 Configure Subsystem Command Summary - Agilent Technologies N9360A Programming Manual

6
Programming Command Summary
Table 6-3 DISPlay Subsystem Command Summary
Item
File Management

Configuration Screen

System Configuration Screen

Table 6-4 CONFigure Subsystem Command Summary

Item
Attenuation Control
Beeper Control
10 MHz Reference Oscillator
Date
Panel Key Control
Printer Control
6-4
The CONFigure subsystem commands are used to set the
controls and parameters associated with the basic system
requirement, file management, test condition, and test sequence
screens.
The following commands are used to set the reference signal
oscillator source, date and time, beeper, RF attenuation,
firmware update, and so forth, which are fundamentally
required to operate the Tester.
Command
CONF:LOSS ON|OFF|1|0
CONF:LOSS?
CONF:LOSS:RFIN <<
<real 1>,<real 2>,<real 3>,<real 4>,<real 5>,<real 6>
CONF:LOSS:RFIN?
CONF:LOSS:RFOU <<
<real 1>,<real 2>,<real 3>,<real 4>,<real 5>,<real 6>
CONF:LOSS:RFOU?
CONF:BEEP ON|OFF|1|0
CONF:BEEP?
CONF:ROSC?
CONF:DATE <int YYYY>,<int MM>,<int DD>
CONF:DATE?
CONF:PKEY UNLOCK|LOCK
CONF:PKEY?
CONF:PRIN PMG800|USBM
CONF:PRIN?
Command
DISP:CONF:FILE
N9360A Multi UE Tester W-CDMA Programming Manual