Agilent Technologies N9360A Programming Manual page 121

N9360A Multi UE Tester W-CDMA Programming Manual
Modulation
RFGenerator:MODulation OFF|IDLE| <<
IDLE+DPCH(PN9)| IDLE+DPCH(PN15)| <<
IDLE+DPCH(PN9)+OCNS| IDLE+DPCH(PN15)+OCNS
RFGenerator:MODulation?
This command defines a type of modulation. The parameter is
, ,
OFF IDLE IDLE+DPCH(PN9)
IDLE+DPCH(PN9)+OCNS
this is set to .
OFF
• : Outputs carrier wave without modulation.
OFF
• : Outputs CPICH, P-CCPCH, SCH, PICH, S-CCPCH.
IDLE
• : Outputs IDLE (without S-CCPCH) + RMC
IDLE+DPCH(PN9)
12.2kbps (PN9).
•
IDLE+DPCH(PN15)
12.2kbps (PN15).
•
IDLE+DPCH(PN9)+OCNS
RMC 12.2kbps (PN9) and OCNS.
•
IDLE+DPCH(PN15)+OCNS
RMC 12.2kbps (PN15) and OCNS.
This works with Modulation on the [TX Analyzer] screen.
This is automatically set to
the [TX Analyzer] screen while Modulation on the [Signal
Generator] screen is set to
Analyzer.)
After that, the setting of
changed from the [TX Analyzer] screen to the [Signal
Generator] screen.
This query command returns the selected type of modulation
with strings. The meaning of return value is same as that of the
command parameter.
RF Signal Output Mode
RFGenerator:RFOUtput ON|OFF|1|0
RFGenerator:RFOUtput?
This command selects RF Signal Output status. The parameter
is (1) or (0). At preset, this is set to
ON OFF
the RF Output on the [TX Analyzer] screen.
Programming Command Reference
,
IDLE+DPCH(PN15)
, or
IDLE+DPCH(PN15)+OCNS
: Outputs IDLE (without S-CCPCH) + RMC
: Outputs IDLE (without S-CCPCH),
: Outputs IDLE (without S-CCPCH),
when the screen is changed to
IDLE
. (There is no
OFF
continues when the screen is
IDLE
5
,
. At preset,
setting in TX
OFF
. This works with
OFF
5-75