Mitsubishi Electric MELSEC iQ-R Series User Manual page 487

[Md.132] Operation cycle setting
Stores the current operation cycle.
Storage value
1004H
1005H
1006H
1007H
1008H
Refresh cycle: At power supply ON
■Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 400 System monitor data
[Md.133] Operation cycle over flag
This flag turns ON when the operation cycle time exceeds operation cycle.
Storage value
0
1
Refresh cycle: Immediate
Latch status of operation cycle over is indicated. When this flag turns ON, correct the positioning detail or
change the operation cycle longer than current setting.
■Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 400 System monitor data
[Md.134] Operation time
The time (unit: s) taken for the operation is stored in each operation cycle.
Refresh cycle: Operation cycle
When digital oscilloscope is executed in the following conditions, operation cycle will increase about 30 s.
■Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 400 System monitor data
[Md.135] Maximum operation time
The maximum value (unit: s) of the operation time after each module power supply ON is stored.
Refresh cycle: Immediate
■Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 400 System monitor data
Downloaded from ManualsNet.com
Operation cycle
0.250 ms
0.500 ms
1.000 ms
2.000 ms
4.000 ms
Operation cycle over flag
OFF
ON (Operation cycle over occurred.)
• Probe data: 16CH
• Bit data: 16CH
• Trigger data: 8CH
• Sampling cycle: Same as operation cycle
search engine
12 DATA USED FOR POSITIONING CONTROL
12.7 Monitor Data
12
485