Positioning data to be set
When using speed control (forward run: speed 1 to 4, reverse run: speed 1 to 4), set the following positioning data.
: Always set, : Set as required, : Setting restricted, : Setting not required
Setting item
[Da.1]
Operation pattern
[Da.2]
Control method
[Da.3]
Acceleration time No.
[Da.4]
Deceleration time No.
[Da.6]
Positioning address/movement amount
[Da.7]
Arc address
[Da.8]
Command speed
[Da.9]
Dwell time/JUMP destination positioning data No.
[Da.10]
M code/Condition data No./Number of LOOP to LEND repetitions/Number of pitches
[Da.20]
Axis to be interpolated No.1
[Da.21]
Axis to be interpolated No.2
[Da.22]
Axis to be interpolated No.3
[Da.27]
M code ON signal output timing
[Da.28]
ABS direction in degrees
[Da.29]
Interpolation speed designation method
*1 When using 2- to 4-axis speed control, it is necessary to set the axis to be used as the interpolation axis.
Refer to the following for information on the setting details.
Page 452 Positioning data
3 MAJOR POSITIONING CONTROL
104
3.2 Setting the Positioning Data
Downloaded from
ManualsNet.com
search engine
Setting required/not
Setting required/not
required for the
required for the
reference axis
interpolation axis
*1
*1
*1