List Of Buffer Memory Addresses - Mitsubishi Electric MELSEC iQ-R Series User Manual

Programmable
Hide thumbs Also See for MELSEC iQ-R Series:
Table of Contents

Advertisement

12.2
The following shows the relation between the buffer memory addresses and the various items.
Do not use the buffer memory address that is not described here since they are for "Maker setting".
References for the list of buffer memory addresses in this section are shown below.
Buffer memory address
Buffer memory addresses for positioning data
Buffer memory addresses used in synchronous
control
Buffer memory addresses used in network
*1 Simple Motion Module Setting Function  "Help(H)"  "Buffer Memory Address List(B)"
For the enable timing of each parameter, refer to the following.
Page 550 Details of areas
[Basic setting]
■Servo network composition parameters
n: Axis No. - 1
Item
[Pr.101]
Virtual servo amplifier setting
[Pr.140]
Driver command discard detection setting
[Pr.141]
IP address
[Pr.142]
Multidrop number
■Common parameters
Item
[Pr.82]
Forced stop valid/invalid selection
[Pr.152]
Maximum number of control axes
[Pr.156]
Manual pulse generator smoothing time constant
■Positioning parameters: Basic parameters 1
n: Axis No. - 1
Item
[Pr.1]
Unit setting
[Pr.2]
Number of pulses per rotation (AP)
[Pr.3]
Movement amount per rotation (AL)
[Pr.4]
Unit magnification (AM)
[Pr.7]
Bias speed at start
Downloaded from
ManualsNet.com

List of Buffer Memory Addresses

Reference
"Help" in "Simple Motion Module Setting Function" of the engineering tool
Refer to "List of Buffer Memory Addresses (for Synchronous Control)" in the following manual.
MELSEC iQ-R Motion Module User's Manual (Advanced Synchronous Control for Simple Motion
Mode)
Refer to "Buffer Memory" in the following manual.
MELSEC iQ-R Motion Module User's Manual (Network)
search engine
*1
Buffer memory address
Axis 1 to axis 16
58022+32n
58023+32n
58024+32n
58025+32n
58028+32n
Buffer memory address
Axis 1 to axis 16
35
58003
58011
Buffer memory address
Axis 1 to axis 16
0+150n
2+150n
3+150n
4+150n
5+150n
1+150n
6+150n
7+150n
12 DATA USED FOR POSITIONING CONTROL
12.2 List of Buffer Memory Addresses
12
397

Advertisement

Table of Contents
loading

Table of Contents