Mitsubishi Electric MELSEC iQ-R Series User Manual page 486

[Md.64] Network error number
When a network error is detected, the error code corresponding to the error details is stored.
• This area always stores the latest error code. (Whenever the network error occurs, a new error code replaces the stored
error code.)
• The error No. is cleared when "[Md.23] Axis error No." of all axes are cleared. (Set to "0".)
• The error No. is cleared when the [Clear Error] button of GX Works3 is clicked. (Set to "0".)
Refresh cycle: Main cycle
■Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 400 System monitor data
[Md.130] F/W version
The first two digits of the module firmware version is stored.
• Monitoring is carried out with the string display.
Refresh cycle: At power supply ON
■Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 400 System monitor data
[Md.131] Digital oscilloscope running flag
Stores the RUN status of digital oscilloscope.
Storage value
0
1
-1
Refresh cycle: Main cycle
■Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 400 System monitor data
12 DATA USED FOR POSITIONING CONTROL
484
12.7 Monitor Data
Downloaded from ManualsNet.com
• When an error code of a moderate error is stored, no error code of a minor error is stored.
• When an error code of a major error is stored, no error code of a minor/moderate error is stored.
Digital oscilloscope RUN status
Stop
Run
Stop by error
• When an error occurs in setting data of digital oscilloscope at power supply ON, "-1: Stop by error" is stored.
Write the setting again using an engineering tool.
• When the offline digital oscilloscope function is validated, "1: Run" is stored from the start of the unit. If an
engineering tool is not compatible with the offline digital oscilloscope function, the operation to set "0: Stop"
cannot be executed. Therefore, update to the latest engineering tool.
search engine