Appendix 1.3 Network Parameter Setting; Appendix 1.4 Remote Password Setting - Mitsubishi L02CPU User Manual

Appendix 1.3
For the network parameters of CC-Link, refer to the following.
MELSEC-L CC-Link System Master/Local Module User's Manual
Appendix 1.4
This section provides the remote password setting screens and details of the setting items.
Item
Password Setting
Model Name
Start X/Y
Condition (detailed setting)
User Connection No.
Password
Active
Module
System Connection
Setting
Regard as Error when Remote
Pasword Mismatch Count Reaches
Upper Limit
After setting a remote password, store the parameters in the parameter-valid drive.
Network Parameter Setting
Remote Password setting
Enter a remote password.
Select a model name of the CPU module.
Set the start address of the module.
When selecting the L02CPU or L26CPU-BT, detailed
settings are required.
Select a user connection number(s).
Select a port(s) where the remote password is
enabled.
Set whether to generate an error when the number
of mismatches on remote password reaches to the
upper limit.
Upper Limit of Set the upper limit of the number of remote
Mismatch password mismatches.
Description
Up to four characters (alphanumeric
characters, special symbols)
0000
Connection 1 to Connection 16
Deselected
1 to 65535 (default: 10 (Count))
APPENDICES
Setting range
• LCPU
• LJ71C24
to 0FE0
H H
⎯
• MELSOFT Transmission Port (TCP/IP)
• MELSOFT Transmission Port (UDP/IP)
• FTP Transmission port (TCP/IP)
• Direct Connection of MELSOFT
303
APPEN
DIX