Fire Safety Requirements For Juniper Networks Devices; General Fire Safety Requirements; Figure 45: Esd Point On The Mx104 Router Chassis; Figure 46: Placing A Component Into An Electrostatic Bag - Juniper MX104 Hardware Manual

Related
Documentation

Fire Safety Requirements for Juniper Networks Devices

Copyright © 2014, Juniper Networks, Inc.
Appendix A: Safety and Regulatory Compliance Information for the MX104 Router

Figure 45: ESD Point on the MX104 Router Chassis

0 1

Figure 46: Placing a Component into an Electrostatic Bag

NOTE: Figure 46 on page 121
MX104 routers.
Connecting the MX104 Router to Earth Ground on page 51
General Fire Safety Requirements on page 121
Fire Suppression on page 122
Fire Suppression Equipment on page 122

General Fire Safety Requirements

In the event of a fire emergency involving network devices, the safety of people is the
primary concern. Establish procedures for protecting people in a fire emergency, provide
safety training, and properly provision fire-control equipment and fire extinguishers.
In addition, establish procedures to protect your equipment in a fire emergency. Juniper
Networks products should be installed in an environment suitable for electronic
equipment. We recommend that fire suppression equipment be available in the event
of a fire in the vicinity of the equipment, and that you observe all local fire, safety, and
electrical codes and ordinances when installing and operating your equipment.
2 3
shows a component that is not supported on
121