Fire Safety Requirements For Juniper Networks Devices; General Fire Safety Requirements; Figure 30: Esd Point On Acx1000 And Acx1100 Routers; Figure 31: Placing A Component Into An Electrostatic Bag - Juniper ACX1000 Hardware Manual

Related
Documentation

Fire Safety Requirements for Juniper Networks Devices

Copyright © 2013, Juniper Networks, Inc.
Appendix A: Safety and Regulatory Compliance Information for the ACX1000 and ACX1100 Router

Figure 30: ESD Point on ACX1000 and ACX1100 Routers

ACX1000
MGMT
ALARM
CONSOLE/AUX
SYS 0
1— ESD point

Figure 31: Placing a Component into an Electrostatic Bag

NOTE: Figure 31 on page 83
ACX Series routers.
Connecting the ACX1000 or ACX1100 Router to Earth Ground on page 41
General Fire Safety Requirements on page 83
Fire Suppression on page 84
Fire Suppression Equipment on page 84

General Fire Safety Requirements

In the event of a fire emergency involving network devices, the safety of people is the
primary concern. Establish procedures for protecting people in a fire emergency, provide
safety training, and properly provision fire-control equipment and fire extinguishers.
In addition, establish procedures to protect your equipment in a fire emergency. Juniper
Networks products should be installed in an environment suitable for electronic
equipment. We recommend that fire suppression equipment be available in the event
T1/E1 GE
0/0/4 0/0/5 0/0/6 0/0/7 0/1/4 0/1/5 0/1/6
1PPS 10MHz
IN OUT IN OUT
0/0/0 0/0/1 0/0/2 0/0/3 0/1/0 0/1/1 0/1/2
shows a component that is not supported on
1
0/1/7 0/2/2 (Cu) 0/2/3 (Cu)
0/2/0 (SFP) 0/2/1 (SFP) 0/2/2 (SFP) 0/2/3 (SFP)
0/1/3 0/2/0 (Cu) 0/2/1 (Cu)
COMBO PORTS
83