Omron FH series User Manual page 85

Hide thumbs Also See for FH series:

Table of Contents

Command Area

Set Communications Output Status

Set Parallel Terminal Status

Set All Parallel Terminal Statuses

Set All Parallel DO Terminal Statuses

Set Operation Log State

Commands to Read Data

Command Area

Get Unit Data

Get Data Logging Conditions

Get Parallel Terminal Offset

Commands to Write Data

Command code for

Command Area

Set Unit Data

Set Data Logging Conditions

Set Parallel Terminal Offset

Vision System FH/FZ5 Series User's Manual

for Communications Settings (Z342)

Command name

EtherCAT Connections (FH-1000 series/FH-3000 series only)

Enables/disables outputs to external devices.

Sets the ON/OFF status of the specified par-

allel I/O terminal.

Sets the ON/OFF status of all parallel termi-

nals, except for DO terminals

Sets the ON/OFF status of all parallel DO ter-

Sets the state of the operation log.

Gets the unit data.

Gets the conditions that are set for data log-

Gets the parallel DI terminal offset data that is

Sets the unit data.

Sets the data logging conditions.

Sets the parallel DI terminal offset data.

Troubleshooting