Omron FH series User Manual page 247

(2) Set the connections as shown in the following table.
Originator device (PLC) settings
Input tag set: EIPOutput
Output tag set: EIPInput
5
Accessing the Communications Areas from the User Program
The defined variables are used to access the communications areas for the Sensor using the following
• Command Area
Signal name
EXE
STEP
XEXE
ERCLR
DSA
Command code
Command parameter 1
Command parameter 2
Command parameter 3
• Response Area
Signal name
FLG
BUSY
OR
RUN
XFLG
XBUSY
XWAIT
ERR
GATE
Command code
Response code
Response data
• Output Area
Signal name
Output data 1
Output data 8
Vision System FH/FZ5 Series User's Manual
for Communications Settings (Z342)
Target device (Sensor) settings
Output tag set: Input101
Input tag set: Output100
Variable name
EIPOutput.ControlFlag.F[0]
EIPOutput.ControlFlag.F[1]
EIPOutput.ControlFlag.F[8]
EIPOutput.ControlFlag.F[15]
EIPOutput.ControlFlag.F[16]
EIPOutput.CommandCode
EIPOutput.CommandParam1
EIPOutput.CommandParam2
EIPOutput.CommandParam3
Variable name
EIPInput.StatusFlag.F[0]
EIPInput.StatusFlag.F[1]
EIPInput.StatusFlag.F[3]
EIPInput.StatusFlag.F[4]
EIPInput.StatusFlag.F[8]
EIPInput.StatusFlag.F[9]
EIPInput.StatusFlag.F[10]
EIPInput.StatusFlag.F[15]
EIPInput.StatusFlag.F[16]
EIPInput.CommandCodeEcho
EIPInput.ResposeCode
EIPInput.ResposeData
Variable name
EIPInput.OutputData[0]
EIPInput.OutputData[7]
Communicating with EtherNet/IP
2
245