Omron FH series User Manual page 105

Event name Change in Connected Camera
Meaning The Camera that is connected is different from when data was last saved.
Source EtherCAT Master Function Module
Error attributes Level
Effects User program
EtherCAT NET RUN
Indicators
Variable
System-defined
variables
None
Assumed cause
The Camera connection information in
Cause and
the scene data does not agree with the
correction
connection information for the Cam-
era connected to the Controller.
Attached
None
information
Precautions/ This error will occur if you load system and scene group 0 data (bkd file) that was edited with simulation software to the
Remarks Controller. Save the data to the Controller and restart the Controller.
Vision System FH/FZ5 Series User's Manual
for Communications Settings (Z342)
Source details
Minor fault Recovery
Continues. Operation
EtherCAT NET ERR
---
Data type
Correction
Connect a Camera that agrees with
the Camera connection information in
the scene data or edit the scene data
according to the connection informa-
tion for the Camera connected to the
Controller.
EtherCAT Connections (FH-1000 series/FH-3000 series only)
Event code 385A 0000 hex
Slave Detection timing
Error reset (after
resetting the error Log category
in the slave)
The Camera image can be input, but an unintentional num-
ber of Camera pixels, color, or monochrome information
may be measured.
EtherCAT LINK/ACT
---
Name
---
Prevention
Make sure that the Camera connection
information in the scene data agrees
with the connection information for the
Camera connected to the Controller.
After turning ON
slave power
System
2
---
---
103