Omron FH series User Manual page 466

IMGSAVE
Saves image data.
<Command format>
<Response format>
When processing is performed normally
When processing is not performed normally
<Parameters explanation>
Image data No.
Destination folder
name
*1: The maximum number of images that can be logged depends on the model of the Sensor Controller that you use and the
models and number of connected Cameras. For details, refer to
Series User's Manual (Cat. No. Z365) for the maximum number of images that can be logged (I_MAX).
*2: Do not specify a save destination other than RAMDisk or External memory, i.e. C:\ProgramFiles\FZ
The saved Scene data area may be reduced and the Sensor Controller will not perform correctly.
IMPORTANT
• If the specified file name already exists, this existing file will be overwritten
• Do not turn off power to the Sensor Controller until there is a response.
464
Command Control
Specifies the No. of the image data to be saved (0 to max. number of logging images (I_MAX)).
The maximum number of logging images can be a number with a maximum of 3 digits. The number
of images will vary depending on the Sensor Controller used and the camera connected. The
image data number of the latest image is 0.
Refer to About Number of Logged Images in the Vision System FH/FZ5 Series User's Manual
(Cat. No. Z365)
The folder name to save image data.
Specify the folder name as an absolute path.
The file name needs the "IFZ" extension.
The save destination to use differs by Sensor Controller model.
Save destination FH series/FZ5-1100 series
RAMDisk C:\Data\RAMDisk
External memory E:\, F:\, G:\, H:\, M:\ (FH series only)
*2
FZ5-L series/FZ5-600 series
\RAMDISK
\USBDisk to \USBDisk3
Number of Logged Images in the Vision System FH/FZ5
Vision System FH/FZ5 Series User's Manual
for Communications Settings (Z342)
*1