Omron FH series User Manual page 387

Hide thumbs Also See for FH series:

Table of Contents

Get All Parallel DI Terminal Statuses

Gets the ON/OFF states of all parallel DI terminals at once.

For how to set, refer to the following:

When you want to acquire the Parallel DI terminal status of Line 0.

1. Send a command to get the Parallel DI terminal at once to the specified port number of Line0.

2. All of the Parallel terminal status are responsed.

Command (PLC to Sensor Controller)

First word in

Command Area

Response (Sensor Controller to PLC)

First word in

Response Area

Vision System FH/FZ5 Series User's Manual

for Communications Settings (Z342)

Command code

Command code

Response target command codes

Response code

Command execution result

OK: 0(0000 0000)

NG: Not 0 (0000 0000)

Response data

Parallel DI terminal status (0: OFF / 1: ON)

Parallel DI terminal can be assigned to the BIT of

Response data.

This assignment differs by the Sensor Controller

series or by line in use.

For more details, refer to

Command Control

Troubleshooting