Omron FH series User Manual page 171

Setting
item
Address setting 2
Address Settings is only for the following series:
• FH-1000 series (2 camera type)
• FH-3000 series (2 camera type)
• FH-L series Sensor Controller
• Obtain an IP address automatically
• [Use the following IP address]
IP address
Subnet mask
Default gateway
DNS server
Preferred WINS server
Alternate WINS server
Input/Output settings
Output IP Address/TCP
*1
Server
Input/Output port No.
Vision System FH/FZ5 Series User's Manual
for Communications Settings (Z342)
Set value [Factory default]
a.b.c.d
a: 1 to 223
b: 0 to 255
c: 0 to 255
d: 2 to 254
[10.5.6.100]
0.0.0.0 to
255.255.255.255
[255.255.255.0]
a.b.c.d
a: 1 to 223
b: 0 to 255
c: 0 to 255
d: 2 to 255
[10.5.6.100]
a.b.c.d
a: 1 to 223
b: 0 to 255
c: 0 to 255
d: 2 to 255
[10.5.6.100]
a.b.c.d
a: 1 to 223
b: 0 to 255
c: 0 to 255
d: 0 to 255
[0.0.0.0.]
a.b.c.d
a: 1 to 223
b: 0 to 255
c: 0 to 255
d: 0 to 255
[0.0.0.0]
a.b.c.d
a: 0 to 255
b: 0 to 255
c: 0 to 255
d: 1 to 254
[0.0.0.0]/[10.5.5.101]
0 to 65535
[9600]/[9876]
Set the IP address of the bottom Ethernet port on
the Sensor Controller.
Same as [Address setting].
Inputs address of WINS server.
Inputs address of WINS server.
Input the output destination IP address.
*1: When you connect with the TCP.
[TCP Server] is displayed.
Factory default value is [10.5.5.101].
*1
Set the port No. to use for data I/O with the Sensor
Controller.
*2
*2: When you connect with the TCP.
Factory default value is [9876].
Description
Communicating with PLC Link
2
169