Switches the scene group number
Switches the scene group number to be used.
<Command format>
<Response format>
When processing is performed normally
When processing is not performed normally
<Parameters explanation>
Scene group No.
(Example)
When switching to scene group 2
<Command>
<Response>
IMPORTANT
• During parallel continuous measurement and when the STEP signal is input continuously, do not perform switching of
the scene group. When this is performed, set "Unchecked" in "Save scene group on switch scene" in either of the
settings items below.
• Switch Scene Group window (Reference:
User's Manual (Cat. No. Z365)
• [Measure setting] in the [Measure] menu (Reference:
Measurement in the Vision System FH/FZ5 Series User's Manual (Cat. No. Z365)
500
Command Control
Specifies the scene group No. after switching (0 to 31).
Changing the Scene or Scene Group in the Vision System FH/FZ5 Series
Setting the Conditions That Are Related to Operation during
Vision System FH/FZ5 Series User's Manual
for Communications Settings (Z342)